The areas right above the eye and the center of the eyebrow require a little finer work to be done. In order to obtain the best results possible, the best eyebrow bending and to completely hide any rebellious hairs, you will need to zoom in very close to those areas and use smaller brushes. After having editing these areas tool, remove the unwanted patterns using the Healing Brush Tool.

If it the first time you are performing these actions in Photoshop, you might find it harder and you may make some mistakes. Any errors performed while editing can be corrected by using the “Eraser Tool” and any wrong steps can be undone by pressing Ctrl+Z (the Undo command) or the Alt+Ctrl+Z command (step backward).

Create a new layer by clicking the “Create a new Layer” icon which is situated in the layers palette. The dialog window for the new layer will appear on the screen. Name this new layer “Right Eyebrow”. Now, use the same steps used for the left eyebrow to fix this one as well.

After you finished editing, you may notice that the resulted eyebrows are a bit too sharp. Select the “Blur Tool” from the tool bar and soften the edges. Use a “Strength” amount of 50% for start, but you can increase or decrease this setting depending on your results. When using the Blur tool, be careful not to blur away any details in the skin or the eyebrow hairs. Only apply the blur to the edges.

When you are finished correcting the eyebrows, lock the “Left Eyebrow” and the “Right Eyebrow” layers by making them active and then clicking on the lock icon, which you will see at the top of the layers palette. By locking these layers, you avoid making future adjustments to a wrong layer by mistake.

After you have corrected your model’s eyebrows, it is time to deal with the other imperfections the face may have, such as the wrinkles. Create a new layer (click on the Create New Layer icon in the layers palette) and name this new layer “Left Wrinkles”.

Select the “Healing Brush Tool” which is situated in the tool bar .The Healing Brush Tool’s dialog window will appear. Modify the values for “diameter” and “hardness” to 20 and 0% respectively. Let the other options (spacing, angle and roundness to their default values).